2001 Ford F-150 Cylinder Head DISASSEMBLY AND ASSEMBLY
download Cylinder Head Special Tool(s) Compressor, Valve Spring 303-567 (T97P-6565-AH) Spacer, Valve Spring Compressor 303-382 (T91P-6565-AH) Installer, Valve Stem Oil Seal 303-383 (T91P-6571-A)...
View Article1998 Ford Expedition Main Control Valve Body Removal Installation
download 1. If equipped, turn the air suspension switch OFF. 2. Disconnect battery ground cable. 3. Raise and support the vehicle; refer to Section 100-02. 4. Drain transmission fluid and remove the...
View ArticleAudi A4 Sedan 2002-2004, Audi A4 Avant 2002-2004, Audi A4 Cabriolet 2003-2004...
Check the following wire connection for open circuit according to wiring diagram:Relay carrier in E-box, plenum chamber, position 3Terminal Harness connector atignition coils Terminal 8 1 Specified...
View Article2001 Ford Escort Cylinder Head Disassembly
download 1. Remove the bolt and the camshaft position (CMP) sensor. 2. Remove the bolts, the rocker arm seats, and the rocker arms. 2. Remove the bolts, the rocker arm seats, and the rocker arms. 3....
View ArticleENGINE MISFIRE 2003-2004 Mustang, 1999-2004 Navigator 2002-2003 Blackwood...
download Some 1999-2004 Navigator, 2002-2003 Blackwood, 2003-2005 Aviator, 2003-2004 Marauder and 2003-2004 Mustang vehicles built before 12/19/2004 equipped with 4.6L 4V/5.4 4V engine may exhibit a...
View Article1999 Dodge Durango Housing Assembly HVAC: Service and Repair Heater – A/C...
download The heater-A/C housing assembly must be removed from the vehicle and disassembled for service access of the blower motor, blower motor wheel, heater core, evaporator coil, blend-air door, and...
View Article2001 Chevrolet Cavalier Idle Air Control Motor (IAC): Service and Repair...
download 1. Remove the idle air control (IAC) valve connector. 2. Remove the IAC valve attaching screws (1). NOTE: If the IAC valve has been in service: DO NOT push or pull on the IAC valve pintle. The...
View Article1996 Ford Taurus valve body Removal and Installation
download REMOVAL NOTE: The oil pump and valve body are removed as an assembly. 1. Disconnect battery ground cable, then remove battery, battery tray, and remote air cleaner. 2. Position supply hoses,...
View Article1992 Suzuki Swift VALVE CLEARANCE ADJUSTMENT
download NOTE: Samurai & Sidekick 1) Remove rocker cover. Rotate crankshaft until zero degree (TDC) timing mark of timing belt cover is in line with timing mark on crankshaft pulley. 2) Cylinder...
View Article1995 Ford Windstar VALVE CLEARANCE ADJUSTMENT
download NOTE: Hydraulic valve lifters are used; no valve adjustment is required. When valve and/or valve seat is machined, valve clearance is reduced and may cause improper valve operation. Different...
View Article
